Categories
Contact Us

Jinan Quick-Fulltek CNC Machinery Co.,ltd

Add:3600 West Airport Rd., Lingang Economic Development Zonegaoxin District, Jinan, China

Mobile:86-15628788695

Email:vivien@quickcncrouter.com

News
Home > News > Content
Choose The Right Lubrication Method
Jul 09, 2018

In the daily use of Wuhan woodworking engraving machine, more attention should be paid to maintenance work. Choosing the right lubrication and curing method and lubricating oil can improve the running function of the machine, reduce wear and prolong the service life of the engraving machine. Here are some common-sense questions about how to choose a lubricant and use a lubricant:

1. Economical engraving machine chooses lubricant: a mixture of oil and butter, not too thick.

2, lubrication part: x.y.z three-axis screw. Light bar.

3. Lubrication step: Before the lubrication, remove the impurities on the lead screw and the wire nut and the bearing inside the guide rail. If it can not be removed, it can be cleaned with gasoline. After the lubricant is injected, the speed will be increased and the air will be emptied. Plate, three-axis running-in.

4. Lubrication cycle: Depending on the working environment and machine working time, it is generally cleaned up after work every day. Refueling every part of the month and lubricating at high speed.

5, lubrication method: Y-axis: lubrication is relatively simple, the guide rails on both sides are easier to clean the oil, and the bottom screw can also enter the oil from the bracket, so it is easier to maintain. The X-axis needs to be removed from the front and rear screws, and a shield is lifted. (Note: the line on the left side of the side panel should be loosened and then lifted up) Right, fully lift the mixed oil into the guide rail, the lead screw, the bearing and the right side. The thrust bearing of the screw head. At the Z axis, the shroud, the lead screw, the guide rail, and the thrust bearing at the bottom of the bearing are opened at a glance. The work done at this time is: lubrication of the mixed oil in the up and down operation.

When lubricating the three shafts, the inner hexagonal screws on the coupling between the motor shaft and the screw head can be tightened by the inner hexagonal wrench to prevent the three shafts from being misaligned due to loose mechanical parts.


  • Newsletter
  • Categories
  • Contact Us

    Jinan Quick-Fulltek CNC Machinery Co.,ltd

    Add:3600 West Airport Rd., Lingang Economic Development Zonegaoxin District, Jinan, China

    Mobile:86-15628788695

    Email:vivien@quickcncrouter.com

  • QR Code
  • Copyright © Jinan Quick-Fulltek CNC Machinery Co.,ltd. All Rights Reserved.