Categories
Contact Us

Jinan Quick-Fulltek CNC Machinery Co.,ltd

Add:3600 West Airport Rd., Lingang Economic Development Zonegaoxin District, Jinan, China

Mobile:86-15628788695

Email:vivien@quickcncrouter.com

News
Home > News > Content
Convenient For Daily Table Top Operation And Meeting The Requirements Of Firmness
Jul 09, 2018

There is a certain standard for installing the whole cabinet. Only when it is installed correctly according to the standard, will it feel comfortable when used. So, what is the standard for the installation of the whole cabinet? The following is a brief introduction to the whole house customization.

What is the standard for the installation of the whole cabinet?

1. Clean and hygienic. It should be civilized during installation. The site should be cleaned before construction; the site should be cleaned during the construction process; the site should be cleaned up and rectified in time.

2. Special production. In order to adapt the cabinet to different environments, good installation should be partially enhanced. It adopts 5-wire waterproofing technology to specially treat the anti-fog and waterproof performance of the rear edge of the sink cabinet.

3. Balance the effort. The cabinet adjustment feet must be properly adjusted to ensure that all the adjustment feet can be smoothly placed at the same time, so that the cabinet is balanced and safe. At the same time, it is possible to avoid loosening of the cabinet structure due to uneven force.

4. Easy to lubricate. All hardware accessories, baskets, slide rails and other products in the cabinet must be adjusted for key items such as screw spacing and resistance during installation, so that all accessories are smooth and easy to use, and can extend the service life.

5. Uniform appearance. During the installation process of the cabinet door, after reasonable system deployment by hinges, support rods, etc., it must be ensured that the door panels are flat from any angle, because the uneven panel not only affects the appearance, but also affects the door hinges, etc. The life of the accessory.

6. Leveling is level. When installing cabinets, when performing cabinet assembly and counter liners, it is necessary to ensure that the countertops and cabinets are in a horizontal position as a whole to facilitate daily tabletop operation and meet the requirements of firmness.


  • Newsletter
  • Categories
  • Contact Us

    Jinan Quick-Fulltek CNC Machinery Co.,ltd

    Add:3600 West Airport Rd., Lingang Economic Development Zonegaoxin District, Jinan, China

    Mobile:86-15628788695

    Email:vivien@quickcncrouter.com

  • QR Code
  • Copyright © Jinan Quick-Fulltek CNC Machinery Co.,ltd. All Rights Reserved.